Thread

Original GameCube ‘Wiimote’ prototype

Started by SuperH - 2 Jun 2019, 07:52

6Replies
3KViews
5Participants

Top posters

SuperHSuperH3 posts
These were used for early development on the GameCube prior to Wii hardware being ready and are known to have been distributed to a number of big studios (c2005).

The buttons have been directly taken from the GBA SP (down to the rubber pads being cut with scissors to fit!).

A debug menu in the prototype for GC Metroid 3 shows a ‘revolution’ Subheading and freelook modes which may relate to this controller, however that protos requirement of a 128MB RAM GC precludes testing on any known GC or Wii Systems (the RAM layout on NDEV and RVT-H being different despite meeting the 128MB req).
12
I will be jealous of this forever.
1
muramasa said:
I will be jealous of this forever.

They’re appearing on Yahoo Japan every couple of months. I think I’ve seen five or so sold in the past several months.
1
Yes, here’s a photo of the full setup.

I remember seeing that Sphear game but as far as I’m aware it’s not dumped and I contacted the owner last year but he never replied.

I’m pursuing an option to get some original demos running with an SN ProDG devlink (sent one of these controllers to a buddy who has one and familiar with the original code); should get to him next week and I’ll post any findings.
2
Shane Battye said:
A debug menu in the prototype for GC Metroid 3 shows a ‘revolution’ Subheading and freelook modes which may relate to this controller, however that protos requirement of a 128MB RAM GC precludes testing on any known GC or Wii Systems (the RAM layout on NDEV and RVT-H being different despite meeting the 128MB req).


SN TDEV units have more RAM than other dev GC systems. Do they read the Metroid Prime 3 demo ?
The Pictures dont seem to load sadly :(